Engineering & project support
Compressed air piping services, from plant survey to commissioning.
Design, flow and diameter selection, project estimation, ROI analysis, quotation support, installation guidance and training for modular aluminium distribution networks.
End-to-end capability
A technical partner for efficient, future-ready plant distribution.
ShiftAir supports projects from initial plant assessment and network design through material planning, installation guidance, commissioning and technical support.
The engineering approach considers air demand, operating pressure, route length, pressure drop, air velocity, future expansion and the fittings required for a reliable closed-loop or branch distribution layout.
- Customised plant layout design
- Pipe sizing and routing selection
- Bill of Materials and cost estimation
- Energy-saving and ROI analysis
- Turnkey installation support
- On-site guidance and team training
Layouts are engineered for smooth full-bore transmission, modular expansion and reduced leak risk.
Technical assistance
Six services that move a project from concept to execution.
Select a service to view its role, project inputs and typical deliverables.
Project workflow
From plant requirement to a commissioned network.
A structured delivery path keeps sizing, material planning, installation and handover aligned.
Requirement capture
Application, flow demand, pressure, compressor capacity and expansion plans.
Plant survey
Route conditions, pipe lengths, drops, equipment points and installation constraints.
Engineering
Diameter selection, routing, accessories, slope and pressure-drop optimisation.
BOQ & proposal
Transparent Bill of Materials, project estimate and commercial quotation.
Execution
Material supply, modular assembly, installation guidance and on-site support.
Handover & support
Commissioning, team training, documentation and ongoing technical consultation.
Design engineering
Every layout is evaluated as an operating system—not just a pipe route.
Design support is built around reliable delivery pressure, controlled velocity, low pressure loss, safe installation and the ability to extend the network later.
Installation guidance
Technical details that protect performance after installation.
ShiftAir guidance addresses routing, thermal movement, support, condensate management and modular joint assembly.
Evaluate straight-run lengths and use expansion joints, loops or flexible hoses where temperature variation requires movement.
Use directional slope, top take-offs and drain points at the lowest ends of main and sub-headers.
Position clips to avoid sag and vibration while permitting controlled thermal movement.
On-site guidance, manuals and training support correct push-fit or clamp-fit assembly.
Applications
Engineered for diverse manufacturing environments.
The catalogue identifies these sectors as core application areas for ShiftAir systems and technical services.
Quality commitment
10-year warranty support.
The catalogue states that ShiftAir will repair or replace components that fail because of a manufacturing or material defect within ten years of installation, subject to the stated operating and inspection conditions.
- Products must operate within recommended technical parameters.
- ShiftAir engineers require access to inspect the affected product.
- Unauthorised modifications, mishandling or operation outside limits can invalidate coverage.
Project execution
Installation references from the ShiftAir catalogue.
Examples show overhead ring mains, vertical drops, compressor-room connections and machine-level distribution.
Overhead distribution
Compressor room
Vertical drops
Isolation point
Plant distributionProject enquiry
Get a plant-specific recommendation.
Share your location, application, compressor capacity, required pressure and approximate pipe length. The engineering team can use these inputs for layout, sizing and quotation support.
Request technical consultation
Front-end form layout. Connect it to Forminator, CRM or your preferred enquiry handler.
Elementor note: replace this preview form with a Shortcode widget containing Module ID attribute is required! when you want to use the existing Forminator form.
